ILIFT SUSPENSION HOW TO

If aftermarket shock absorbers are installed.For vehicles with magnetic ride, disconnect.Under curb weight, torque nut (1) to 81.1.

A pry bar may be needed to reduce tension.

Remove screws securing front trunk bucketīucket carefully while disconnecting the two.

Remove emergency release latch assembly.

Remove four screws from front trunk bucket.Remove left and right trim panels removing.Height at jack points on all four corners. Before raising vehicle, measure factory ride.Wireless Configuration & Proximity Sensor Calibration (optional) Proximity Sensor Installation (optional)Ģ9 6. Install Washer / Compressor AssemblyĢ5 4. Install Washer / Compressor AssemblyĢ4 b. Washer / Compressor Assembly Installationġ0 b. Remove Rear Shock Absorbers (for optional rear lift onlyĢ.

ILIFT SUSPENSION HOW TO

Visit this site for video for a tutorial on how to install the iLIFT actuator:Ĥ d.Spring compressor for factory shock absorbers (wall-mounted style recommended).Standard automotive & electrical tools.Consult factory service manual for all torque values.The installation kit includes threaded perches allowing ride height adjustment. Installation of iLIFT Systems on factory shock absorbers required optional factory shock absorber installation kit from.Some items may only be used off road in some states. Installation of these products must be performed by a competent and knowledgeable installer. Under consideration for the purchase of theseĬomponents, the buyer agrees to release, indemnify and hold Suspension Lift Technologies LLC harmless for, and assume all risk of any injury or damages that may arise from the installation or use No warranty is made or implied for products sold through Suspension Lift Technologies LLC against protection from damage, injury, or death.

Ilift suspension